Wood, teeth, bamboo, carbon, jade carving, color carving resin wood carving

Crafts classification
Wood, teeth, bamboo, carbon, jade carving, color carving resin wood carving
Handed down the wood carving process and sculpture techniques:
(A) the characteristics of wood and the selection of some Cartier love bracelet replica soft wood, some rough, easy to soft wood easy to carve, rough Shen
Heavy hard carving. Woody tough, fine texture, bright color called hardwood, such as mahogany, boxwood, rosewood, almond, wood, etc., with all the advantages of carving, is the carving of the finest materials, suitable for carving complex structure Fine works, but also in the production process and preservation is not easy to break damage, a high collection value, just carved more costly, easy to damage the tool. Relatively loose wood suitable for beginners, such as linden wood, ginkgo wood, camphor wood, pine and so on. This kind of wood for carving modeling simple structure, the image of the more general works, carved up also easier, but because of its soft wood, weak color, and some need to color processing to enhance the sense of volume. Some wood grain is more obvious and varied, such as: Ash, pine, fir, etc., you can use the smooth grain, grain texture, for some more lyrical works. In general, the greater the ups and downs of the shape, the richer the change of grain, the more flavor; the shape of the shape of the more Cartier love ring replica dynamic, smooth, the effect of grain is more ideal, as well as unexpectedly good, Rich decorative. Of course, this wood design should be based on a high degree of general summary, too complex and too small volume, not only will damage the grain, but also cause visual contrast.
Therefore, before the creation of a work, we must first understand the wood, choose the material is suitable for the performance is very important.
(B) the drying of wood 1, artificial drying: the wood sealed in the steam drying room, by steam to promote water
Sub-evaporation, so that wood dry. (Depending on the size of the wood, thickness, such as 4cm plate drying time generally takes a week), the highest degree of dryness can make the wood water content of only 3%. But after the high temperature evaporation of wood crisp toughness is easy to be damaged and not conducive to carving. Usually the degree of drying of the logs should be kept at about 30% of the water content. 2, natural drying: the classification of wood placed in the ventilation (plate, just or logs), shelved into the stack, stack off the ground about 60cm, leaving the middle of the gap, so that air circulation, take away the water, wood gradually Replica Cartier jewelry dry. Naturally dry to go through a few years or months, in order to achieve a certain dry requirements. 3, simple manual drying: First, the use of fire dry wood internal moisture. The second is to boil the resin composition of the wood, and then put in the air dry or dry. The drying time of these two methods may be shortened, but the wood after the invasion of water easily discolored, detrimental to wood.

Leave a Reply